ag旗舰厅下载客户端

欢迎访问 web name官网!

收藏显进| XML地图| 网站地图| 关于显进

全国服务热线:86-010-12345678

搜索关键词:

当前位置:Home >> Solution >> View Details

Design of electrostatic discharge of PCB plate and the solutions

产品分类:
    订购热线:86-010-12345678

      In the design of PCB board, can be layered, proper layout and installation of anti ESD design and implementation of PCB. By adjusting the PCB layout, can be very good to prevent ESD. * multilayer PCB is used as far as possible, the double PCB, the ground plane and power plane, and closely spaced signal earth line spacing can reduce common mode impedance and inductance coupling, so as to achieve the double PCB 1/10 to 1/100. For the top and bottom surfaces are components, with a short connecting line.
      From the human body, the environment and internal electronic equipment for semiconductor chip precision electrostatic will cause damage, such as through the components inside the thin insulating layer; a gate MOSFET lesion and CMOS components; CMOS device triggers lock; short PN junction reverse biased; short road to biased PN junction; active devices within the melting welding wire or wire. In order to eliminate the electrostatic discharge (ESD) interference and damage to the electronic equipment, need to take a variety of technical means of prevention.
      In the design of PCB board, can be layered, proper layout and installation of anti ESD design and implementation of PCB. In the design process, through the forecast can be modified only to increase or decrease the vast majority of design components. By adjusting the PCB layout, can be very good to prevent ESD. The following are some of the common measure.
      * multilayer PCB is used as far as possible, the double PCB, the ground plane and power plane, and closely spaced signal earth line spacing can reduce common mode impedance and inductance coupling, so as to achieve the double PCB 1/10 to 1/100. As each signal layer are close to a power supply layer or ground layer. For the top and bottom surfaces are components, with a short connecting wire and a lot of filling high density PCB, can consider to use the inner line.
      * for a double PCB, by closely interwoven power and ground grid. Power line is close to the ground, between vertical and horizontal line or fill area, as much as possible to connect. The size of the grid side is less than or equal to 60mm, if possible, the grid size should be less than 13mm.
      * make sure that every circuit as compact as possible.
      As far as possible to all connectors are put aside.
      If possible, the introduction of the power line from the card and away from the central, to be directly influenced by ESD region.

      * 表示必填采购:Design of electrostatic discharge of PCB plate and the solutions
      Title
      content
      name
      telephone
      QQ
      address
      Email
      字段5
      verify code*click it to change

      相关资讯

        • I want to comment

          content*
          Your name
          verify code* 
        产品中心Product List

        联系我们

        服务热线:86-010-12345678

        电话:86-010-12345678

        传真:86-010-12345678

        联系邮箱 12345@qq.com

        联系地址:Room 906, 8th Building Spring Garden, XueYuan Road HaiDian District Beijing China